ABB RMC-100 - Page 78

78 | RMC-100| 2105552MNAE
Figure 5-5: Factory default Display setup (Advanced view)
IMPORTANT NOTE:
This procedure changes the number of display groups to two. The factory
default group is intact. A new display group is configured to display application
-specific values in
section
5.4.3 Configure a display group. Configure additional display groups for your scenario as
required.
To establish the number of display groups:
1. Click Display on the navigation tree to display the Setup tab.
Figure 5-6: Default Display setup
2. Type into Number of Display Groups the number of the groups to scroll and display on the LCD.
In this example, type 2 into the field (Figure 5-7
).