Section 3 Run-time Operation AO815/AO845
3BSE027630-600 B 103
Channel area
Mark the Deactivate check box if the channel shall not be used.
Make the required choices in the Signal range and the OSP control drop-down
menus.
If the alternative “Set OSP value” is chosen, you can type your own value (0-100%)
in the OSP value text field.
Mark the Output filter check box if it shall be used. Should be set when using
HART.
Figure 45. AO815 and AO845 - Configuration - Channel Parameters Tab
To Next Page
Loading...
