Section 2 Installation Language Setting
3BSE027630-600 B 23
Language Setting
S800 I/O DTM supports English.
Backup
It is recommended to use a standard software to create a backup of the memory
medium (CD). This backup helps to save the data if the medium is damaged, or in
the event of a fatal error on the computer.
Ensure that the backup is clearly marked and carefully maintained.
Initial Installation
Sequence
The S800 I/O DTM consists of a single program to install all DTMs.
The installation process is the same for all components and is therefore described
only once.
Installation Procedure
This procedure describes the manual installation, and needs to be referred only if
the automatic installation of S800
IO DTM is not performed along with the
Control System installation.
To install the S800 I/O DTM componen
t through command prompt, do the
following steps:
1. Run the command prompt (administrator login) and change it to the drive
w
here the builds are copied, for example D drive would be D:/,
2. Enter cd <space>
Path.
Enter the folder path where the build is available.
To Next Page
Loading...
