ABB S800 I/O - Product Scope

Product Scope Section 1 Introduction
18 3BSE027630-600 B
The following drives are considered to be standard drives:
• ACS600 with standard application
• ACS800 with standard application
• ACS600 with crane application
• ACS800 with crane application
• ACS600 with pump and fan application (PFC)
• ACS800 with pump and fan application (PFC)
• ACS400 with standard drive
• DCS400 with standard drive
• DCS500 with standard drive
• DCS600 with crane application
Product Scope
The S800 I/O DTM version 6.0 is suitable for executing various tasks, also referred
to as applications in the following description. The applications have a graphical
user interface. The product also contains DTMs that has HART tool routing
functionality. Tool routing describes a mechanism to enable sub connected DTMs,
such as the Basic HART DTM to communicate through a S800 I/O DTM to HART
instruments connected to a S800 I/O module. For this function no graphical user
interface is required.
The following are examples of available applications:
• About DTM
• Identification
• Diagnosis
• Configuration
•Observe
• Parameterization
• Service