Section 3 Run-time Operation AO801/AO810/AO820
3BSE027630-600 B 99
With a new diagnosis scan, the DISAPPEARED and APPEARED bits are
cleared.
AO801/AO810/AO820
About DTM
See About DTM on page 39.
Identification
See Identification on page 40.
Dynamic Data
See AO801/AO810/AO815/AO845/AO890/AO895 Dynamic values on page 154,
and AO820 Dynamic values on page 155.
Diagnosis
See Diagnosis on page 41.
Observe
See Observe on page 44.
Configuration
This control is not available if the unit is used towards AC 800M. The
configuration data is then set via Control Builder Professional.
For configuration of the module, select the “Configuration” menu item.
It shows the user parameters of the module, i.e. Signal range, OSP Value.
To Next Page
Loading...
