Section 3 Run-time Operation DO890
3BSE027630-600 B 137
Service
The service control is used for reading acyclic data and is only visible if the module
is configured via a CI840. The Service redundancy tab is as shown in Figure 34.
Module status area
In the Module status area you can see which I/O module that is primary. By
clicking the Update button you update the status for which of the I/O module that
are the primary.
DO890
About DTM
See About DTM on page 39.
Identification
See Identification on page 40.
Dynamic Data
See DO890 Dynamic values on page 166.
Diagnosis
See Diagnosis on page 41.
Observe
See Observe on page 44.
Configuration
This control is not available if the unit is used towards AC 800M. The
configuration data is then set via Control Builder Professional.
To Next Page
Loading...
Need help?
General
