AI835/AI835A Section 3 Run-time Operation
72 3BSE027630-600 B
AI835/AI835A
About DTM
See About DTM on page 39.
Identification
See Identification on page 40.
Dynamic Data
See AI801/AI810/AI815/AI830/AI835/AI845/AI890/AI893/AI895 Dynamic values
on page 151, and AI835A Dynamic Values on page 152.
Diagnosis
See Diagnosis on page 41.
Observe
See Observe on page 44.
Configuration
This control is not available if the unit is used towards AC 800M. The
configuration data is then set via Control Builder Professional.
Configuration consists of two tabs. The Module parameters tab shows the user
parameters for the module and the Channel parameters tab shows parameters for the
channels, i.e. Signal range and Filter time.
The difference between the AI835 and AI835A modules is that AI835A has some
supplementary features.
AI835A supports the same thermocouple types as AI835 and additionally TC
types D, L and U. AI835A has also a possibility to use remote cold junction
compensation. It is possible to insert an AI835A in an configuration as
replacement for AI835, but not the other way around.
To Next Page
Loading...
