Section 3 Run-time Operation About DTM
3BSE027630-600 B 39
About DTM
For general information, directly related to the S800 I/O DTM, select the “About
DTM” menu item. It will show the DTM version information.
DP840 X X X X X X
ABB
Standard
Drive
X X X
(1) HART Parameterization only.
(2) The module supports SOE (Sequence Of Events), but this feature can only be used in a frame application that
also supports SOE.
Figure 8. About DTM
Table 3. Applications available for the S800 I/O DTM (Continued)
Module
About
DTM
Identifi-
cation
Diagnosis Observe
Configurati
-on
Parameter
-ization
Service
To Next Page
Loading...
