AO890 Section 3 Run-time Operation
106 3BSE027630-600 B
HART Primary module fails, HART communication does not switch over
automatically to the other unit. The user must manually do the switchover.
AO890
About DTM
See About DTM on page 39.
Identification
See Identification on page 40.
Dynamic Data
See AO801/AO810/AO815/AO845/AO890/AO895 Dynamic values on page 154.
Diagnosis
See Diagnosis on page 41.
Observe
See Observe on page 44.
Configuration
This control is not available if the unit is used towards AC 800M. The
configuration data is then set via Control Builder Professional.
For configuration of the module, select the “Configuration” menu item.
To Next Page
Loading...
