ABB S800 I/O - DO801;DO802;DO810;DO814;DO815;DO818;DO820;DO821;DO828 Module Details

Section 3 Run-time Operation
3BSE027630-600 B 131
DO801/DO802/DO810/DO814/DO815/DO818/DO820/DO821
/DO828
About DTM
See About DTM on page 39.
Identification
See Identification on page 40.
Dynamic Data
See DO801/DO810/DO814/DO828/DO840 Dynamic values on page 163, DO818
Dynamic values on page 164 and DO802/DO815/DO820/DO821 Dynamic values
on page 165.
Diagnosis
See Diagnosis on page 41.
Observe
See Observe on page 44.
Configuration
This control is not available if the unit is used towards AC 800M. The
configuration data is then set via Control Builder Professional.
Configuration consists of two tabs. The Module parameters tab shows the user
parameters for the module and the Channel parameters tab shows parameters for
separate channels.
* Feature Pack Functionality