Section 1 Introduction ABB Standard Drive Integration
3BSE027630-600 B 17
All DTMs are used to operate the S800 I/O modules in a frame application
conforming to applicable parts of FDT version 1.2 and addendum.
ABB Standard Drive Integration
ABB Standard drives can be connected to the S800 I/O system. The FCI works as a
communication link between the fieldbus master and the drives. No application
software concerning this functionality is stored in the FCI. Check the available
support for each FCI type.
DO815 Digital Output 24 V d.c. 2 A short circuit proof, 2*4
channels
DO818 Digital Output 24 V d.c., 32 channels
DO820 Digital Output Relay 8*1 channels 24-230 V a.c.3 A cos
0.4 d.c. < 42W
DO821 Digital Output Relay 8*1 normally closed channels 24-
230 V a.c./d.c.
3 A cos 0.5 d.c. < 42 W
DO828 Digital Output 230 V a.c., 16 channels
DO840 Digital Output 24 V d.c. 0.5 A,
2*8 channels, Extended Diagnosis, Redundant
Applications
DO890 Digital Output 12 V 40 mA, I.S. interface, 1*4 channels,
Galvanic isolation between channels
DP820 Incremental Pulse Counter, 2 channels, maximum 1.5
MHz. Interface for RS422, current 5 V, 12 V and 24 V.
DP840 Incremental Pulse Counter, 8 channels, maximum 20
kHz. Interface for NAMUR 12 V and 24 V. For single
and redundant applications.
(1) 1*16, equals 1 group of 16 channels
(2) 2*8, equals 2 groups of 8 channels
Table 1. S800 I/O Units (Continued)
Units Description
To Next Page
Loading...
