3BSE027630-600 B 29
Section 3 Run-time Operation
Introduction
This section describes how to operate the DTM with the applications in a frame
application, for example Fieldbus Builder.
After the DTMs are installed, start the frame application and locate
the S800 I/O DTM. See appropriate documentation for handling of
the frame application.
Data Storage
The data (parameters) is only available temporarily in the DTM for processing.
When a user interface is closed or data is buffered, the DTM saves the data
permanently.
In off-line mode, data is saved in Frame Application. In on-line mode, data is saved
first to the I/O module and then to the database.
However, the DTM will only update the data in the database if the I/O module
has accepted the data.
This section is also available as Online Help.
To Next Page
Loading...
