Section 3 Run-time Operation DP840
3BSE027630-600 B 143
DP840
About DTM
See About DTM on page 39.
Identification
See Identification on page 40.
Dynamic Data
See DP840 Dynamic values on page 171.
Diagnosis
See Diagnosis on page 41.
Observe
See Observe on page 44.
Configuration
This control is not available if the unit is used towards AC 800M. The
configuration data is then set via Control Builder Professional.
Configuration consists of two tabs. The Module parameters tab shows the user
parameters for the module and the Channel parameters tab shows parameters for
separate channels.
To Next Page
Loading...
