Section 3 Run-time Operation AO815/AO845
3BSE027630-600 B 105
In the Module status area you can see which I/O module that is treated as primary
by CI840. By clicking the Update button you update the status for which of the I/O
module that are the primary.
The HART Primary unit does not have to be identical with the Primary unit
described in this control. The HART Primary unit is set in the Service Control in
Engineering mode.
HART Primary Tab
The HART Primary Tab is only shown in Engineering mode. Here you select
through which unit HART communication should happen.
The HART Primary unit can be, but does not have to be, identical with the unit
treated as primary by CI840 seen in Service Control in Commissioning mode. If the
Figure 47. AO845 - Service - HART Primary Tab
To Next Page
Loading...
