Section 3 Run-time Operation DP840
3BSE027630-600 B 145
Channel parameters tab
Figure 70. DP840 - Configuration - Channel Parameters Tab
Channel area
Mark the Deactivate check box if the channel shall not be used.
Make the required choices in the Filter time, Pulse count/Freq measure and
Interval Timer drop-down menus.
Service
The service control is used for reading acyclic data and is only visible if the module
is configured via a CI840. The Service redundancy tab is as shown in Figure 34.
Module status area
In the Module status area you can see which I/O module that is primary. By
clicking the Update button you update the status for which of the I/O module that
are the primary.
To Next Page
Loading...
