Abov E-OCD II - E-OCD II Power Out to Target System

E-OCD II Debugger User’s Manual E-OCD II Interface Hardware
17
2.1.5 E-OCD II Interface Disconnection
The target system must be powered off before disconnecting the OCD interface to avoid damage to
the interface module.
2.1.6 E-OCD II Power Out to Target System
E-OCD II can Power out to target system two types of voltages(3.3V, 5.0V). User can select the
output voltage using a switch on E-OCD II. And then push the power button icon on OCD debugger
program.
1) Select power voltage 3.3V or 5.0V on E-OCD II switch
2) Target Power OFF
3) Push the button icon on OCD Debugger program.