Abov E-OCD II User Manual

Introduction E-OCD II Debugger User’s Manual
4
1 Introduction
1.1 E-OCD II The Chip and Onboard Debugging Solution
E-OCD II is short for ‘Enhanced On-Chip Debugger’. E-OCD II is a debugger tool for ABOV 8bit MCU.
E-OCD II is MCU debugging control via 2pin or 3pin (added RunFlag) OCD interface. E-OCD II is
dedicated to onboard programming and debugging via serial interfaces (DSCL, DSDA). E-OCD II
debugger supports all of ABOV’s M8051 devices.
In particular, the E-OCD II adds protection circuitry to the input and output ports for tough board-level
manufacturing lines for added durability and safety. E-OCD II is advanced function for USB driver,
Power out, low level detection more than OCD II. Power out function only supports 50mA current
consumption environment.
1.1.1 Software Requirements
The following operating systems must be used to install and run the E-OCD II debugger. Both 32-bit
and 64-bit versions are available.
 Microsoft Windows Vista
 Microsoft Windows 7
 Microsoft Windows 8 & 8.1
 Microsoft Windows 10
If you wish to carry out a full installation of the software, up to 20MB of hard disk space is required.
1.1.2 Hardware Requirements
The following are the minimum hardware requirements for installing and running the E-OCD II
debugger.
 USB port
 Performance is based on the following factors:
 Processor performance
 USB port performance
The E-OCD II debugger is not affected by the USB version (V1.0, V1.1, V2.0, or higher).

Abov E-OCD II Specifications

General

Brand	Abov
Model	E-OCD II
Category	Computer Hardware
Language	English