Chapter 3, Preparing the devices
Accu-Chek Smart Pix user's manual
3-9
3.6 Accu-Chek Go
The Accu-Chek Go meter has a built-in infrared port for data
transfer. In order to read data from these devices, proceed as
follows:
• Place the device no more than 10 cm away from the
infrared window on the Accu-Chek Smart Pix device.
Both infrared windows must be facing one another.
• Switch the meter on by keeping the
M
button pressed
for more than 3 seconds.
• The display shows “PC”, and data transfer starts
automatically.
If you have the Accu-Chek Go meter version shown in the
illustration to the left, proceed as follows:
• Place the device no more than 10 cm away from the
infrared window on the Accu-Chek Smart Pix device.
Both infrared windows must be facing one another.
• Switch the meter on by pressing the and
buttons simultaneously.
• The display shows “PC”, and data transfer starts
automatically.
To Next Page
Loading...
Need help?
General