Chapter 3, Preparing the devices
3-10
Accu-Chek Smart Pix user's manual
3.7 Accu-Chek Mobile
The Accu-Chek Mobile meter has a built-in infrared port for
data transfer. In order to read data from these devices,
proceed as follows:
• Place the device no more than 10 cm away from the
infrared window on the Accu-Chek Smart Pix device.
Both infrared windows must be facing one another.
• Keep the and buttons pressed until the meter
turns on
• Wait for the display check to be completed and the
Transfer data
menu to be displayed.
•In the
Transfer data
menu, select
For analysis
and press
.
The connection is now established, and the data is
transferred. When data transfer has been completed, the
Transfer finished
display is shown for two seconds. Then, the
meter turns off.
To Next Page
Loading...