Chapter 4, Accu-Chek Report
Accu-Chek Smart Pix user's manual
4-1
4 Accu-Chek Report
If you have initiated the transfer of data from a meter, an
insulin pump or the Accu-Chek Pocket Compass software, as
described in the previous chapter, the following now occurs:
• The top/bottom dots on the status indicator flash
quickly during the data transfer. Make sure not to
move the devices during this process, so as not to
interfere with the data transfer.
• When the data has been transferred, the Accu-Chek
Smart Pix system prepares the reports. The two left/
right dots on the status indicator flash (more slowly)
during this process.
• When the reports have been completed, the centre of
the status indicator is lit continuously. This means the
reports are now available on the computer and the
device search has been switched off (standby mode).
The data stored in the meter or insulin pump is not deleted
after data transfer.
The Accu-Chek Smart Pix system creates reports
(Accu-Chek Report) with various graphic and statistical
analyses. All the elements of a report are always available on
the screen. Your decision on which report elements to print
out can be made on a case-by-case basis.
To Next Page
Loading...
Need help?
General