Chapter 3, Preparing the devices
Accu-Chek Smart Pix user's manual
3-11
3.8 Accu-Chek Sensor/Advantage
The Accu-Chek Sensor/Advantage meters use the contacts
for the code chip as an interface for data transfer. In order to
read data from these devices, proceed as follows:
• Leave the device switched
off
during the entire
process.
• Remove the code chip from the meter.
• Remove the Accu-Chek IR Key
5
from the slot on the
back of the Accu-Chek Smart Pix device (if that is
where you store it).
• Insert the Accu-Chek IR Key into the meter in place of
the code chip.
• Place the device no more than 10 cm away from the
infrared window on the Accu-Chek Smart Pix device.
Both infrared windows must be facing one another.
• Data transfer starts automatically.
When data transfer has been completed and the report is
displayed on the screen:
• Remove the Accu-Chek IR Key from the meter and
return it to the place where you normally store it (e.g.
the slot on the back of the Accu-Chek Smart Pix
device).
• Re-insert the code chip into the meter.
To Next Page
Loading...