www.accuenergy.com
V: 1.0 Revised: Jan. 2018
Chapter 5: Viewing Real-Time Readings via Acuview Software
53
5.2.3 Configure the data log to log the readings on the computer’s memory
This applies to AcuDC 240 series meters with communication option; the meters do not
need to have onboard memory since the data will be logged directly on the computer’s
memory.
You can set up the meter to log data directly on the computer memory. You must always
be connected to the software for this data log method to work.
You can access this data log setting by clicking on the ‘Settings’ option located on the
menu toolbar, and then clicking on ‘Data Log Settings’ or click the icon
In data log setting, as shown in Fig 5-7, make sure you check the ‘Enabled’ box in the
window.
Under the ‘Logging Items of Selection’ Section: click on the required groups of
parameters you will like to log.
Under the ‘Logging Options’ Section:
Fig 5-6 Accessing Data Log
The Data Log Setting window will open. This is shown in Fig 5-6.
To Next Page
Loading...
Need help?
General
