AccuWeb MICRO 4000 NET - Page 110

Output Array bytes 0 and 1 Operating Mode Command - continued
Byte Bit Function Value
Switchpad
Type
Action Performed
(Param 51)
Select Input B.
0
Note: To
select Centerline mode, set the Input A and B
command bits to 0 and the Centerline command bit to 1.
Select Input B.
1
Note: To
select Centerline mode, set the Input A and B
command bits to 1 and the Input C command bit to 0.
1
1 Input B
Select Input B and Automatic mode.
2
Note: To
select Centerline mode, set the Input A and B
command bits to 1 and the Input C command bit to 0.
0 x No change.
0
0 Select Centerline mode.
Select Input C.
1
Note: To
select Centerline mode, set the Input A and B
command bits to 1 and the Input C command bit to 0.
Input C
1
2
Select Input C and Automatic mode.
Note: To
select Centerline mode, set the Input A and B
command bits to 1 and the Input C command bit to 0.
0 or
Centerline
0 x No change.
Fieldbus Interface
107
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com