ERROR MESSAGES
In the case of malfunction or an event error, the display will indicate an error code together with acoustic signals (5 beeps). Furthermore an
error symbol is shown on the display, warning the operator about the error status.
All functions are inhibited until the error status is xed or restored.
Some errors can be cleared by pressing the reset button on the keypad.
Le graphique suivant comprend une liste de message d’erreur pouvant apparaître lors du fonctionnement du système radiographique X-
MIND unity.
The following chart gives a list of error messages that will appear should the X-MIND unity experience a malfunction.
The error codes have the following format:
• The letter “E” followed by a number that identies the faulty unit (timer or tubehead)
• “1”: Fault is located in the timer (control unit)
• “2”: Fault is located in the tubehead
To Next Page
Loading...
