Wires next to high voltage with dimmers or
electronic ballasts are particularly susceptible to
noise
.
DigiLink cards with analog switches can pick up noise from
the analog switch wires. These should not be run near to
power lines and should be shielded if over 100 ft long.
If you have any problems resolving error counts please call
the factory at 800 345 4448.
7) Push the buttons on the switches and make sure that
they work and that they control the right loads. Verify the
action of the system.
8) Call the factory and have them check out the modem if
there is one. (800) 345 4448.
9) Train the end users on the operation of the system. Par-
ticularly make sure that they understand what a blink warn-
ing is (that they need to press the Override Button if they
Always call the factory at (800) 345-4448 for help.
Definitely call the factory 1 week before
turn over to the client f or final check out.
Page 62
want the light to stay ON.) Make sure that they know
where the switches are.
Also instruct them on how to use the Manual override
switch on the cards to turn ON the system in event of cat-
astrophic failure. Alternatively, if they have normally
closed relays, turn off the breaker that controls the elec-
tronics to relax relays to ON.
Make sure they know our 800 number and tell them that
they have free lifetime programming if they bought a
modem with the system.
To Next Page
Loading...
Need help?
General