LC&D 800.345.4448 Pg. 11
SCHEDULE 1 is
programmed and has
no loads.
SCHEDULE 3 is not
programmed.
SCHEDULE 4 is
programmed and
controls GROUP 4.
SCHEDULE 6 is
programmed, has
loads, but is disabled.
Refer to page 10
for information on
Group Types.
USER MENU
MANUAL OVERRIDE
REVIEW SCHEDULE
GROUP LOADS
PROGRAM SWITCH
SETUP MENU
SCHEDULES PAGE 1-6
Name: SCHEDULE 1
SCH 1 ==> NO LOADS
SCH 2 UNUSED
SCH 3 UNUSED
SCH 4 ==> GROUP 4
SCH 5 UNUSED
SCH 6 ==> DISABLED
GROUP 1 MAINTAIN
EDIT: LCP-1 LOAD-1
PROGRAMMING GROUPS
To Access the Group:
Within the DTC, there are two paths you can use
to access a group for programming purposes:
A) From USER MENU:
1. TAB to start.
2. TAB to GROUP LOADS.
3. ENTER to select.
B) From the SCHEDULE MENU:
1. EXIT schedule when complete.
2. TAB to NO LOADS.
3. ENTER to select.
1. SCROLL to select Group Type (see page 10
for selecting group types).
2. Add or delete loads (see page 5 for adding or
deleting loads).
NOTE: If using MAINTAIN + TIMER or MAINTAIN
+ BLINK, press ENTER when highlighted to set
parameters.
For more extensive data on programming the GR
2400 system, download the complete manual
from the CD that came with the system or from
www.lightingcontrols.com/downloads.
GROUP LOADS
NO LOADS
MAINTAIN
To Next Page
Loading...
Need help?
General