364
uuHomeLink® Universal TransceiveruTraining HomeLink
Training HomeLink
If it is necessary to erase a previously entered
learned code:
• Press and hold the I and III HomeLink
buttons for about 10 seconds, until the
green indicator blinks. Release the buttons,
and proceed to step 1.
• If you are training the second or third
button, go directly to step 1.
The instructions on the next page should work for most gate or garage openers, but
may not work for all. For detailed instructions about your specific remote opener,
visit http://www.homelink.com or call (800) 355-3515.
III HomeLink
Button
Indicator I HomeLink Button
21 ACURA RDX-31TJB6210.book 364 ページ ２０２０年６月１６日 火曜日 午後１２時３９分
To Next Page
Loading...
