189
192
195
204
208
211
222
230
236
249
Arduino IDE Setup
Using with Arduino IDE
• Blink
• Select ESP32-S2/S3 Board in Arduino IDE
• Launch ESP32-S2/S3 ROM Bootloader
• Load Blink Sketch
Arduino Blink
• Pre-Flight Check: Get Arduino IDE & Hardware Set Up
• Start up Arduino IDE and Select Board/Port
• New Blink Sketch
• Verify (Compile) Sketch
• Upload Sketch
• Native USB and manual bootloading
• Enter Manual Bootload Mode
• Finally, a Blink!
I2C Scan Test
• Common I2C Connectivity Issues
• Perform an I2C scan!
• Wiring the MCP9808
LC709203 Simple Data
• Arduino Library Installation
• LC709203 Simple Data Example
WiFi Test
• WiFi Connection Test
• Secure Connection Example
• JSON Parsing Demo
Usage with Adafruit IO
• Install Libraries
• Adafruit IO Setup
• Code Usage
WipperSnapper Setup
• What is WipperSnapper
• Sign up for Adafruit.io
• Add a New Device to Adafruit IO
• Feedback
• Troubleshooting
• "Uninstalling" WipperSnapper
WipperSnapper Usage
• Blink a LED
• Read a Push-Button
• Read an I2C Sensor
• Going Further
Factory Reset
• Factory Reset Firmware UF2
• Factory Reset and Bootloader Repair
• Download .bin and Enter Bootloader
©Adafruit Industries Page 6 of 263
To Next Page
Loading...
Need help?
General
