8230 Optical Power Meter Operation Manual
4.6.2 Remote Control Command List
4-19
System Instrument infor-
mation
*IDN? Query command which inquires for the instru-
ment information.
New model name response
ADC Corp.,8230 ,XXXXXXXXX,YYYYY
ADC Corp.: Manufacturer (9 characters)
8230 : Instrument name (5 characters)
XXXXXXXXX: Serial number (9 characters)
YYYYY: ROM revision number (5 characters)
The new model name response is applied to soft-
ware revision D00 or later.
Old model name response
ADC,Q8230 ,XXXXXXXXX,YYYYY
ADC: Manufacturer (3 characters)
Q8230 : Instrument name (5 characters)
XXXXXXXXX: Serial number (9 characters)
YYYYY: ROM revision number (5 characters)
Information for
options *5
*OPT? Query command which inquires for the instru-
ment option information
Reply: No option 0: (1 character)
Option 70 +70: (3 characters)
User parameter SA0 Saves the setting parameters in area [0] of the
non-volatile memory.
SA1 Saves the setting parameters in area [1] of the
non-volatile memory.
SA2 Saves the setting parameters in area [2] of the
non-volatile memory.
SA3 Saves the setting parameters in area [3] of the
non-volatile memory.
CL Saves the values when shipping in areas [0] to [3]
of the non-volatile memory.
RC0 Loads the values, which are saved in area [0] of
the non-volatile memory, as the setting parame-
ters.
RC1 Loads the values, which are saved in area [1] of
the non-volatile memory, as the setting parame-
ters.
RC2 Loads the values, which are saved in area [2] of
the non-volatile memory, as the setting parame-
ters.
RC3 Loads the values, which are saved in area [3] of
the non-volatile memory, as the setting parame-
ters.
RL Loads the values when shipping as the setting
parameters. *3
*3: MYID and the key lock status are not changed.
*5: This command is applied to software revision C00 or later.
Table 4-5 Remote Control Commands (5 of 7)
Item Command Description
Initial value Availability
Power
ON
Factory
default
Calibration
mode
Error2
To Next Page
Loading...
Need help?
General
