Advanced Motion Controls 12A8 - Products Covered

FIGURE 2.1 AZ Part Numbering Structure
A
Revision
Peak Voltage
Peak Current
-
Additional Options
Blank: Current Mode only
E: Encoder Velocity Mode Available
Maximum peak current rating in Amps
Peak voltage rating scaled 1:10 in Volts
Assigned a letter (A through Z) by manufacturer
PWM Command
H: Hall velocity Mode Available
Brushed DriveBlank:
AZ Analog Drive Series
AZ
Drive Type
DDC: Brushed Drive, PWM Command
B: Brushless drive
BDC: Brushless Drive, PWM Command
Feedback Supported
MNALAZIN-02 5
Products and System Requirements / Products Covered
Products Covered
Theproductscoveredinthismanualadheretothefollowingpartnumberingstructure.
However,additionalfeaturesand/oroptionsarereadilyavailableforOEM’swithsufficient
orderingvolume.FeelfreetocontactADVANCED MotionControlsforfurtherinformation.
Ingeneral,theAZfamilyofanalogdrivescanbedividedintotop‐levelcategoriesbasedonthe
peakcurrentratingofthedrive.Thesecategoriescanbefurtherseparatedintosubdivisions
basedonspecificationssuchaswhetheradriveusesanalogorPWMinput,thetypeof
motor(s)supported,andthefeedbackavailableonthedrive.
TABLE 2.1 Powe
r Specifications
Power Specifications
Description Units AZxx6A8 AZxx12A8 AZxx20A8
DC Supply Voltage Range VDC 20-80 10-80
DC Bus Over Voltage Limit VDC 88
DC Bus Under Voltage Limit VDC 18 9
Maximum Peak Output Current A 6 12 20
Maximum Continuous Output Current A 3 6 12
Maximum Power Dissipation at Continuous Current W 12 24 48
Minimum Load Inductance μH 100
Switching Frequency kHz 31
TABLE 2.2
Control Specifications
Description AZ AZB AZ_DDC AZBDC AZBE AZBH
Command Sources +/- 10V Analog +/- 10V Analog PWM and Direction PWM and Direction +/- 10V Analog +/- 10V Analog
Commutation Methods - Trapezoidal - Trapezoidal Trapezoidal Trapezoidal
Control Modes Current Current Current Current
Current, Open Loop, Encoder
V
elocity, Tachometer Velocity
Current, Open Loop, Hall
Velocity, Tachometer Velocity
Motors Supported Single Phase
Three Phase
Single Phase
Single Phase
Three Phase
Single Phase
Three Phase
Single Phase
Three Phase
Single Phase
Control Specifications
The values and diagrams presented in this chapter are a general drive
"ov
erview". For more detailed information, consult the datasheet for a
specific drive.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com