Advantech Adam-4019+ User Manual

215 ADAM-4000 Series User Manual
Chapter 7 I/O, Relay & Counter
/
Frequency
7.2 Counter/Frequency Module Command
7.2.1 Configuration, Counter Input and Display Command Set
Command Syntax Description I/O Module
%AANNTTCCFF Sets the address, input mode, baud rate, checksum
status and/or frequency gate time for a specified coun-
ter/frequency module
4080,
4080D
$AA2 Requests the return of the configuration data from the
counter/frequency module
4080,
4080D
$AAF Requests the counter/frequency module to return the
version code of its firmware
4080,
4080D
$AAM Requests the counter/frequency module to return its
name
4080,
4080D
$AABS Set the input signal mode of the specified
counter/frequency module to either non-isolated
(TTL) or photo-isolated.
4080,
4080D
$AAB Read the input mode of the specified
counter/frequency module.
4080,
4080D
#AAN Instructs the addressed counter/ frequency module to
read the counter or frequency value of counter 0 or
counter 1 and return the acquired data.
4080,
4080D
$AA8V Select whether LED will display data from the
counter/frequency module directly or from the host com-
puter.
4080D
$AA8 Read the LED Data Origin status which determines
whether LED will display data from the counter/
frequency module directly or from the host computer
4080D
$AA9(data) The host computer sends data to the addressed module
to display on its LED. This command is valid only after
selecting to display host computer data ($AA8V)
4080D

Advantech Adam-4019+ Specifications

General

Brand	Advantech
Model	Adam-4019+
Category	Other
Language	English