EasyManuals Logo

Advantech PCA-684 User Manual

Advantech PCA-684
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
31
3.4.5 Swap Floppy Drive
Logical name assignments of floppy drives can be swapped if there is
more than one floppy drive. The commands are “Enabled” or “Disabled.”
3.4.6 Boot UP Floppy Seek
Selection of the command “Disabled” will speed the boot up. Selection of
“Enabled” searches disk drives during boot up.
3.4.7 Boot Up NumLock Status
This feature selects the “power on” state for NumLock. The commands
are “Enabled” or “Disabled.”
3.4.8 Gate A20 Option
Normal: The A20 signal is controlled by the keyboard controller.
Fast (Default): The A20 signal is controlled by the chipset.
3.4.9 Typematic Rate Setting
The typematic rate is the rate key strokes repeat as determined by the key-
board controller. The commands are “Enabled” or “Disabled.” Enabling
allows the typematic rate and delay to be selected.
3.4.10 Typematic Rate (Chars/Sec)
BIOS accepts the following input values (characters/second) for type-
matic rate: 6, 8, 10, 12, 15, 20, 24, 30.
3.4.11 Typematic Delay (msec)
Typematic delay is the time interval between the appearance of two con-
secutive characters, when holding down a key. The input values for this
category are: 250, 500, 750, 1000 (msec).
3.4.12 Security Option
This setting determines whether the system will boot up if the password is
denied. Access to Setup is always limited.
System: The system will not boot, and access to Setup will be denied
if the correct password is not entered at the prompt.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Advantech PCA-684 and is the answer not in the manual?

Advantech PCA-684 Specifications

General IconGeneral
BrandAdvantech
ModelPCA-684
CategoryPCI Card
LanguageEnglish

Related product manuals