39 PCE-5126 User Manual
Chapter 3 AMI BIOS Setup
Legacy USB Support
This is for supporting USB device under legacy OS such as DOS. When choos-
ing "AUTO", the system will automatically detect if any USB device is plugged
into the computer and enable USB legacy mode when a USB device is plugged
and disable USB legacy mode when no USB device is plugged.
EHCI Hand-off
This enables or disables supporting OS without EHCI hand-off feature.
USB transfer time-out
Allows you to select the USB transfer time-out value. [1,5,10,20sec]
Device reset time-out
Allows you to select the USB device reset time-out value. [1,5,10,20sec]
Device power-up delay
This item appears only when you set the Device power-up delay item to [man-
ual].
USB FLASH DRIVE 1.01*
This item only show when plugging a USB flash device. User can choose
"Auto", "Floppy", "Forced FDD", "Hard Disk" and "CD-ROM" to simulate USB
flash device.
* This item will change wording which depends on what USB storage device you
plug.
3.2.2.9 AMT Configuration
Figure 3.13 AMT Configuration
AMT
"Enable or Disable" Intel Advance Management Technology
Unconfigure AMT/ME
"Enable or Disable" Unconfigure AMT/ME
WatchDog Timer
"Enable or Disable" Watchdog Timer
To Next Page
Loading...
Need help?
General
