Set an optional action delay by tapping Select how soon to start the action after the conditions
are met
Select the (https://support.smartthings.com/hc/articles/115002056363)
(https://aeotec.freshdesk.com/a/solutions/articles/6000240598)Scenes(s)
(https://aeotec.freshdesk.com/a/solutions/articles/6000240598) to trigger
Tap Change this location's mode to change the Location's mode to Away, Night, or Home when triggered
5. Optional: Enter a name for your Automation
6. Tap Save
b.
Example automation
These instructions will walk you through an example of how to turn on a hallway light when there is motion detected
using a motion sensor and a switch/light device.
This is merely an example while this tool is powerful to create customized automation.
Steps in app
1. From the Home screen, tap Plus (+) icon and select Add automation
2. Tap Custom automation
3. Tap the Plus (+) icon below If
4. Tap Based on a device status
5. Select your hallway motion sensor device
6. Tap Motion sensor for the device capability
7. Tap Motion detected for the device state
8. Tap Next
9. Tap the Plus (+) icon below Then
10. Tap Control a device
11. Select your hallway lighting device
12. Tap On for the device action
13. Optional: Tap Select how long to perform this action to automatically turn the light off after a set period of
time
14. Tap Done
15. Optional: Enter a name for your Automation
16. TapSave
c.
Edit a custom automation
You can always edit your custom automation whenever you like if you need to change, add, or swap out devices
you want to trigger and control an automation.
You could deactivate or pause an Automation if you don't want to have it run manually. If you deactivate or pause an
automation, it will not run until you enable it at a later time.
To Next Page
Loading...
Need help?
General