AERMEC SAF - Procedures; Extended Shutdown

SAF_5523451_09
21
PROCEDURES
START-UP
On the Control panel
1. Select "Operation": On.
SWITCH-OFF
On the Control panel
1. Select "Operation": O.
SET POINT SETTING
On the Control panel
1. Press the Programming key and then Enter.
2. Select the "Set point" menu and conrm with the Enter key.
3. Choose the value to edit using the arrow keys.
4. Edit the value and conrm with the button Enter.
CURRENT DATE AND TIME SETTING
On the Control panel
1. Press the Programming key.
2. Select the "Clock" menu and conrm with the Enter key.
3. Select "Set CK1 clock" and conrm with the Enter key.
4. Select "Set CK1 clock" and conrm with the Enter key.
5. Choose the value to edit using the arrow keys.
6. Choose the value to edit using the arrow keys.
ALARMS
In the event of a malfunction, the Alarm symbol lights up:
1. Press the alarm button to display the tripped alarm on the display.
2. Press the Esc key to not reset.
3. Press the alarm key again to reset.
EXTENDED SHUTDOWN
Verify that the Control Panel shows "OFF".
Close the water cocks.
Turn the main dierential QF switch to OFF.
If the temperature drops below freezing, there is danger of freez
-
ing: the equipment’s hydraulic system and circuits must be emp-
tied.