184
Chapter 3 Features and Functions
Remote Interface Configuration
3
Domain Name (LAN) A domain name is a registered name on the
Internet, which is translated into an IP address.
• Front panel operation: There is no way to set the domain name from
the front panel.
• There is no SCPI command to set a domain name.
DNS Server (LAN) DNS (Domain Name Service) is an Internet service
that translates Domain names into IP addresses. The DNS server
address is the IP address of a server that performs this service.
• Normally, DHCP discovers the DNS address information, so you only
need to change this if DHCP is not functional or not in use.
• Contact your network administrator to find out whether DNS is being
used, and for the correct DNS server address.
• Enter the address using the numeric keypad or knob.
• The DNS server address is stored in non-volatile memory and does
not change when power has been off or after a remote interface reset.
• Front panel operation: Press and press the I/O Config softkey.
Then press LAN Settings and Modify Settings. Finally, toggle the
first softkey to read Manual and press More and Primary DNS or
Second DNS to enter a DNS address.
• Remote Interface Operation:
• SYSTem:COMMunicate:LAN:DNS[1|2] "<address>"
To Next Page
Loading...
Need help?
General
