58
Chapter 2 Front-Panel Menu Operation
To Output a Frequency Sweep
2
Note: If desired, you can press the
button and then press the
fourth softkey to set the frequency boundaries of the sweep using a center
frequency and frequency span. These parameters are similar to the start
frequency and stop frequency and are included to give you added
flexibility. To achieve the same results, set the center frequency to 2.525
kHz and the frequency span to 4.950 kHz.
To generate a frequency sweep, press twice. The first press puts
the trigger in manual mode, and the second one sends a trigger. For
more information, see “To Trigger a Sweep or Burst” on page 62.
To Next Page
Loading...
Need help?
General
