Chapter 2 Operating Your Frequency Counter
Using the LIMITS Menu Keys
Operating Guide 2-37
2
6 Press Run key to start the measurement.
7 To turn off the Limit Testing, perform the following steps:
a. Press Limit Modes key until LIM TEST: ON is displayed.
b. Press any one of the arrow keys to toggle Limits OFF.
LIM TEST: OFF is displayed.
When Limit Testing is off, the Limit annunciator, the stop-on-limit capability,
the limit graph, and the rear panel RS-232 Limit Output (if DTR: LIMIT choice
was selected as described in the following Example 5 procedure) are disabled.
NOTE Stats will still filter data using your upper and lower limits if you set Stats to USE: IN
LIMIT.
8 Press Run key to return the Counter to computing statistics on all
measurements.
To Next Page
Loading...
