Chapter 1 Getting Started
Making Measurements
Operating Guide 1-19
1
Starting the Measurement
The Run key initiates repetitive measurements, and is described in the section titled
“To Control Measurement” at the end of this chapter.
To Select Scale and Offset
The Scale & Offset key allows for multiplication and addition, respectively, of the
measurement by user-specified constants. Modification of the displayed measurement
by these Math operations is represented by the following equation:
(Measurement × Scale) + Offset = Displayed Results
The Scale and Offset Math operations can be used, for example, to subtract
systematic errors or display the percentage difference between signals.
Entering the Scale Value
To demonstrate the Scale Math operation, set Scale to 10 as shown in the following
steps.
Run
Freq Ch 1
MHz
Gate
Scale &
Offset
Stats
Scale &
Offset
MATH
To Next Page
Loading...
