Chapter 2 Operating Your Frequency Counter
Using the Print Menu
2-52 Operating Guide
2
Using the Print Menu
Overview of the Print Menu
The Print menu allows you to:
• enable or disable printing (PRINT: OFF or ON).
• get help on how to print (PRT HELP: NO or YES).
To Use the Print Menu
1 Press Save & Print key until PRINT: is displayed.
2 Press any one of the arrow keys, if required, until PRINT: ON is displayed.
When PRINT is enabled, the Counter displays and prints the results for each
measurement. In addition, if STATS: ON, all statistics (that is, standard deviation,
mean, maximum, and minimum) will be printed.
NOTE Printing may slow the update rate of the Counter because the Counter may have to
wait for the printer.
3 Press Save & Print or Enter key.
PRT HELP: NO is displayed.
4 Press any one of the arrow keys to select PRT HELP: YES.
5 Press Enter key.
The instruction “CONFIGURE PORT ON UTILITY MENU; REMEMBER TO
SAVE SETUP FIRST” is displayed.
6 Save your current setup as shown in the section titled “To Use the Save
Function.”
7 Refer to the section in this chapter titled “To Configure the RS-232 Serial Port
for Printing” for information on how to configure and connect the Counter to a
printer.
Save &
Print
Local
To Next Page
Loading...
