Chapter 1 Getting Started
Making Measurements
1-20 Operating Guide
1
Press and hold the d key until the value of Scale is 10 as shown in the following step.
NOTE BE SURE to press the Enter key to enter the value of 10.
The Scale is now set to 10, and MATH has been enabled. The Scale & Offset
indicator is now lit to show that MATH is enabled. Since MATH is enabled, the
results are being scaled and offset.
Entering the Offset Value
To demonstrate the Offset Math operation, set the Offset to 1 MHz as shown in the
following steps.
At this point, pressing the s key will cause the Counter to display the full display of
the Offset value as shown in the following step.
Enter
Scale &
Offset
To Next Page
Loading...
