Chapter 1 Getting Started
Making Measurements
1-24 Operating Guide
1
Setting the Upper Limit
Press the s key nine times to cause the Counter to display your entry in hundreds of
Mega units as shown in the following step.
The leftmost “0” digit in the UPPR display is highlighted as shown above, indicating
that each press of the d key will increase the displayed value.
NOTE BE SURE to press the Enter key to enter the 102 Mega value.
Uppr &
Lower
Limit
Modes
Uppr &
Lower
LIMITS
M
M
M
Enter
M
M
To Next Page
Loading...
