Agilent Technologies 53181A - To Unsave a Measurement Setup

Chapter 2 Operating Your Frequency Counter
Using the Save and Recall Menus
Operating Guide 2-51
2
To Unsave a Measurement Setup
1 To unsave the measurement setup you’ve saved in the previous procedure, press
Save & Print key until UNSAVE: NO is displayed.
2 Press the appropriate arrow keys to select UNSAVE: 1, then press Enter key.
The measurement setup that was saved in register 1 (RECALL: 1) is deleted or
unsaved.
ADDITIONAL INFORMATION ABOUT UNSAVE
If the UNSAVE: display DOES NOT show up after the SAVE: display, then no
setups have been saved; all registers are empty.
If UNSAVE: display is present in the Save & Print key menu, then at least one setup
has been saved. (To determine how many setups are saved, continuously press the d
key while UNSAVE: n is displayed and count the number of registers that are
present.) Perform step 2, below, to delete a measurement setup.
1 Suppose there are two registers (1 and 2) that have setups saved in them. To
remove these setups, perform the following:
a. At the UNSAVE: 1 display, press Enter key.
UNSAVE: 2 is displayed, indicating that register 1 has been cleared. To check
if the clearing was done, press the d key; the “1” display should not exist.
b. At the UNSAVE: 2 display, press Enter key.
All registers are cleared when the UNSAVE menu item is NOT present in the
Save & Print key menu.
2 Now, suppose in the previous step (2) you wanted to leave register 1 alone, but you
want to delete register 2. Perform the following steps:
a. At the UNSAVE: 1 display, press d key.
UNSAVE: 2 is displayed.
b. Press Enter key to delete register 2.