Agilent Technologies 53181A - Preset Values for Functions Accessible Via GPIB Only

Chapter 2 Operating Your Frequency Counter
Preset Values After Power-up and *RST
2-72 Operating Guide
2
Preset Values for Functions Accessible Via GPIB Only
Table 2-7. Agilent 53181A Preset Values—Accessible Via GPIB Only
Description In Save/Recall
Value at *RST
(GPIB Reset)
Value at Power-
Up
In Non-Volatile
Memory
Arming Parameters
Frequency ext stop arm slope yes NEG NEG no
Math, Limit Parameters
Math, limit-test recalculate yes OFF ON no
Reset limit-test fail count on INITiate
yes ON ON no
Statistics Parameters
Statistics type yes MEAN MEAN no
Miscellaneous Measurement
Parameters
Interpolator calibration on/off no ON ON no
Monitor external timebase no TRUE TRUE no
Status Reporting Parameters
Event status enable no ________ 0 no
Service request enable no ________ 0 no
*OPC no disabled disabled no
OSR enable no ________ 0 no
OSR positive transition filter no ________ 1809 no
OSR negative transition filter no ________ 0 no
QSR enable no ________ 0 no
QSR positive transition filter no ________ 17701 no
QSR negative transition filter no ________ 0 no
Error queue no ________ cleared no