Chapter 1 Getting Started
Making Measurements
1-28 Operating Guide
1
Setting the Counter to Flag On Limits But Continue Measuring
Perform the following steps to select the GO ON choice in the ON FAIL display if
you want the Counter to continue measuring even though an measurement result
exceeds the limits previously entered.
The current modified measurement of the input signal applied to CHANNEL 1 is
displayed.
Since the Counter is now in the go-on-fail mode, the Limit annunciator in the display
will light each time a measurement exceeds the limits you set. However, the Counter
will continue to make measurements.
Disabling Limit Testing
The Counter is now making measurements without limit testing.
Limit
Modes
Run
Freq Ch 1
Gate
M
Limit
Modes
To Next Page
Loading...
