Agilent Technologies 53181A - To Set Limits of Measurements

Chapter 1 Getting Started
Making Measurements
Operating Guide 1-23
1
To Set Limits of Measurements
To demonstrate how Math and Limits work together, use the Scale (10) and Offset (1
Mega) values selected in the previous procedure “To Select Scale and Offset.” Enable
Math by performing the following steps.
The result of this Math operation is a measurement of 101 MHz.
(Measurement × Scale) + Offset = Result
(10 MHz × 10) + 1 Mega = 101 Mega
Now, set the upper limit to 102 Mega and the lower limit to100 Mega by performing
the following procedures. (Figure 1-1 and Figure 1-2 illustrate the limits settings.)
Display 1, 7/13/92
Scale &
Offset
Display 1, 7/13/92
Run
Freq Ch 1
M