Chapter 2 Operating Your Frequency Counter
Using the DISPLAY Digits Keys
2-40 Operating Guide
2
To Use the DISPLAY Digits Keys
The following step-by-step procedure describes how to use the Display Digits keys.
In this procedure, you are instructed to blank out all digits below 1 kHz for easier
reading.
1Cycle POWER key to preset the Counter.
2 For demonstration purposes, connect the Counter’s rear-panel 10 MHz Out
signal to channel 1 of the Counter, and press Freq Ch 1 key to measure the
frequency of this signal.
10.000,000,0 MHz is displayed.
3 To blank all digits below 1 kHz, press DISPLAY s (Fewer Digits) key four times.
10.000, _ _ _ , _ MHz is displayed.
To Next Page
Loading...
