Chapter 2 Operating Your Frequency Counter
Using the Utility Menu
Operating Guide 2-53
2
Using the Utility Menu
Overview of the Utility Menu
The Utility menu is accessed by holding the Recall key and cycling POWER key.
The Utility menu allows you to:
• view the firmware revision of your Counter (REV: n).
• select and/or display the current GPIB address (HP- IB: 1, ... 30, or TALK).
• choose timebase source (TIMEBAS: AUTO, INT, or EXT).
• execute several self tests (refer to the paragraph in this section titled “To Run the
Self-Test Routines” for details).
• configure the following parameters for the RS-232 port:
– set the print baud rate (BAUD: 9600, 19200, 300, 1200, or 2400).
– set print parity (PARITY: OFF, EVEN, or ODD).
– set the software pace (SW PACE: XON or NONE).
– set the hardware pace to send data to a serial printer, or to send the Limit-
detect output to a computer or controller, via the RS-232 port (DTR:
HIGH, HW PACE, or LIMIT).
– change the numerical convention of the Counter’s displayed measurement
values. The numeric convention used in the USA separates the integral and
fractional portions of a number with a period (a decimal point), and separates
groups of three digits in the integer portion with a comma. You can reverse
this setting to conform to the numerical convention used in many other
countries (SHOW 9 AS: 9.0 or 9,0).
Recall
Utility Menu:
Hold at power up
Utility
POWER
To Next Page
Loading...
