Contents
iv Operating Guide
The Limit Test Graph Characters at a Glance 1-10
The Rear Panel at a Glance 1-11
Making Measurements 1-12
To Measure Frequency 1-14
To Select Input Coupling and Impedance 1-15
Selecting Input Coupling 1-15
Selecting Input Impedance 1-15
To Set Input Channel Trigger Level/Sensitivity 1-16
Changing Trigger Mode 1-16
Modifying Input Trigger Level 1-17
Selecting Input Trigger Slope 1-18
Selecting Input Sensitivity 1-18
Starting the Measurement 1-19
To Select Scale and Offset 1-19
Entering the Scale Value 1-19
Entering the Offset Value 1-20
Displaying the Math Results 1-21
Disabling Math 1-22
To Set Limits of Measurements 1-23
Setting the Upper Limit 1-24
Setting the Lower Limit 1-25
Setting the Counter to Flag and Stop Measuring On Out-of-Limit
Measurements 1-27
Setting the Counter to Flag On Limits But Continue
Measuring 1-28
Disabling Limit Testing 1-28
Disabling Math 1-29
To Perform Statistics on Measurements 1-29
Selecting the Type of Statistics (Stats) 1-29
Computing Stats on Filtered Data Only 1-31
Displaying Stats After Filtering Data of Input Signal 1-33
Disabling Stats and Math 1-34
To Control Measurement 1-35
To Next Page
Loading...
