110 Troubleshooting and Maintenance Manual
7 Replacement Parts
To Order Parts
To order parts for your MS, address the order or inquiry to your local
Agilent Technologies office. Supply them with the following information:
• Model and serial number of your MS, located on a label on the lower left
side near the front of the instrument.
• Part number(s) of the part(s) needed
• Quantity of each part needed
Some parts are available as rebuilt assemblies
Rebuilt assemblies pass all the same tests and meet all the same specifications
as new parts. Rebuilt assemblies can be identified by their part numbers.
The first two digits of the second part of the part number are 69 or 89 (such as
xxxxx-69xxx or xxxxx-89xxx). Rebuilt assemblies are available on an
exchange-only basis. When you return the original part to Agilent
Technologies (after you receive the rebuilt assembly) you will receive a credit.
If you cannot find a part you need
If you need a part that is not listed in this chapter, check the Agilent
Technologies Analytical Supplies Catalog or the online catalog on the
Worldwide Web at http://www.agilent.com/chem. If you still cannot find it,
contact your Agilent Technologies service representative or your Agilent
Technologies office.
To Next Page
Loading...
Need help?
General
